12V wind turbine solar panel Battery Controller PRE-WIRED ADG BRAIN FastShip USA

Description

WIND / SOLAR CONTROLLER
REPLACEMENT BRAIN ONLY
PRE-WIRED TYPE (SELF POWERING S-H)
The rear
jumper wires are already done for you
and pre-soldered by us  :)
Other boards look the same but they are
not wired to be self powering like ours are!
This is a very different board so be careful
not to
buy boards that are not
self-excited!
FRONT (power wires not included)
BACK -
Self-excited
RED
hot wires.
OPEN BOX USED FOR DISPLAY - DUSTY
Fully programmable for any voltage range you like for 12 volt battery controlling.
(With Original "THER" Thermodyne Controller
. Says THER on the board. Made with real high voltage rated parts.
Some people claim Thermodyne made but only boards stamped "THER" are genuine Thermodyne boards)
NO BASE - NO SOLENOID WITH THIS AUCTION!  For BRAIN-BOARD ONLY
with no power wiring!
(rear jumper wiring is done and soldered and chip comes pre-programmed and ready to run!  Also includes reprogramming instructions should you need to alter
voltage
settings (Also see programming video below)
Requires wiring a solenoid or SSR relay in
order to manage high power (not included)
Onboard relay can handle 10 amps and this
can be used to actuate a 400 amp relay or
solenoid
to
manage BIG POWER.
Can be used on 12 and 24 volt batteries to prevent over charging ALSO.
This model requires a 12 volt
relay or solenoid
for
12 volt system and a 24 volt relay or solenoid for 24 volts systems for controlling larger amounts of power.
(This is how a small brain like this can handle large amounts of power)
This controller can divert or simply disconnect incoming power without an electrical arc occurring -
10 amps maximum  which can drive a larger SOLENOID reyal for bigger jobs.
-
Battery regulator.
Charge regulator.
Charge controller.
Dump load regulator.
"Cut" charge controller.
Diversion load regulator.
Micro processor controlled
Works for all Wind Turbines, Solar panels and Hydro.
For all voltages ranges in multiple battery banks.
No grounded IGBT's or MOSFETS - Lighting strike proof isolation.
Does not waste electricity while
sensing
in  diversion load mode!
HOW POWER DRAW DYNAMICS WORKS:
If you use it as a DIVERSION or DUMP load MODE then it uses no power when it is NOT dumping (energy
efficient
sensing)
ADG Brain only
"Simple and ultra-reliable" - "A BULLET PROOF SYSTEM"